Impala V6-3.5L VIN N (2006)
7. Disconnect the right side spark plug wires from the right side spark plugs.
8. Disconnect the left side spark plug wires from the ignition coil.
9. If replacing only one plug wire, open the retaining clips and remove the spark plug wire.
10. Remove the right side spark plug wire clip from the ignition coil bracket.
11. Remove the spark plug wire assembly.
INSTALLATION PROCEDURE
1. Install the spark plug wire assembly.
2. Install the right side spark plug wire clip at the ignition coil bracket.
3. If only one plug wire was replaced, install the plug wire and close the retaining clip.
4. Connect the right side spark plug wires to the ignition coil.
5. Connect the right side spark plug wires to the right side spark plugs.
6. Install the spark plug wire assembly.
7. Install the left side spark plug wire clips at the intake manifold bracket and heater inlet and outlet pipe.
8. If only one plug wire was replaced, install the plug wire and close the retaining clips.
