Impala V6-3.5L VIN N (2006)
7. Pull back carpet from the front lower right/passenger door pillar to expose the interior fuse center (1), refer to Junction Block Replacement -
Accessory Wiring.
8. Remove the cover then locate and remove the Air Bag Fuse from the interior fuse center.
9. Remove the left/driver outer trim cover from the instrument panel (I/P).
10. Remove the connector position assurance (CPA) from the steering wheel module coil connector (1).
11. Disconnect the steering wheel module coil connector (1) from the vehicle harness connector (3).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the steering wheel module coil connector (1) to the vehicle harness connector (3).
3. Install the CPA to the steering wheel module coil connector (1).
4. Install the left outer trim cover to the I/P.
5. Install both Air Bag Fuses, one in the underhood fuse center and one in the interior fuse center.
6. Replace both fuse center covers.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
SIR Disabling and Enabling Zone 5
