Impala V6-3.5L VIN N (2006)
Check the power steering fluid level and bleed the system. Refer to Power Steering System Bleeding in SI.
The hose section (1) where the leak can occur is shown above. On V8 applications, the fittings are crimped, therefore, the power steering cooler
pipe/hose assembly must be replaced. Use the procedure listed below.
Raise and support the vehicle.
Place a drain pan under the vehicle.
Remove the power steering cooler pipe/hose from the retaining clips on the frame.
Disconnect both stabilizer shaft links from the shaft.
Remove the left side engine mount lower nuts from the frame.
