Impala V6-3.5L VIN N (2006)
12.
Remove the right side engine mount bracket bolts.
13.
Remove the right side engine mount and bracket from the vehicle.
14.
Disconnect the power steering cooler pipe/hose from the gear.
15.
Remove the power steering cooler pipe/hose clamp from the pipe/hose and return line.
16.
Disconnect the power steering cooler pipe/hose from the return line.
17.
Remove the power steering cooler pipe/hose assembly from the vehicle.
18.
Connect the power steering cooler pipe/hose to the return line and install clamp.
19.
Connect the power steering cooler pipe/hose to the gear.
20.
Install the right side engine mount with the bracket to the vehicle.
21.
Install the right side engine mount bracket bolts.
Tighten
Tighten the engine mount bracket bolts to 50 Nm (37 lb-ft.).
22.
Raise the rear of the frame (cradle) using an adjustable jackstand.
23.
Install the rear frame bolts.
Tighten
Tighten the rear frame bolts to 160 Nm (118 lb-ft).
24.
Remove the adjustable jackstand from under the frame.
25.
Lower the transmission and remove support~.
