Impala V6-3.5L VIN N (2006)
Note
-
Two holes will be drilled for retro-fitting 2006 cradles with 2007 cooler pipe.
-
Technician will need to remove one clip from cooler pipe on top and replace with isolator and move the other to the front face of the cradle
(and replace with isolator).
-
Technician will need to glue down the two isolators with Instant Adhesive-Gel, P/N 12345632 (US(, 10953475 (CN), or equivalent, such as
SAF-T-LOK IB-45 (ETHILCIANOCRILATO).
1. Raise and support the vehicle. Refer to the Lifting and Jacking the Vehicle procedure in SI.
2. Place a drain pan under the vehicle to capture the power steering fluid when disconnecting the power steering return line.
3. Remove the air deflector.
4. Remove the power steering cooler pipe/hose from the retaining clips on the frame.
5. Disconnect both stabilizer shaft links from the shaft.
6. Remove the left side engine mount lower nuts from the frame.
