Impala V6-3.5L VIN N (2006)
5. Install the LF door trim panel (2).
6. Connect the roof rail module - left connector to the vehicle harness connector.
7. Install the CPA to the roof rail module - left connector.
8. Install the garnish molding to the upper lock pillar.
9. Connect the seat belt retractor pretensioner - LF connector (2) to vehicle harness connector (1).
10. Install the CPA (3) to the seat belt retractor pretensioner - LF connector (2).
11. Install the lower center pillar trim.
12. Install both Air Bag Fuses, one in the underhood fuse center and one in the interior fuse center.
13. Replace both fuse center covers.
14. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
15. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System