Impala V6-3.5L VIN N (2006)
Stabilizer Link: Service and Repair
Front Suspension
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise the vehicle and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the stabilizer shaft link bolt and nut.
4. Remove the stabilizer shaft link from the vehicle.
Installation Procedure
1. Install the stabilizer link into the vehicle.
2. Notice:
Refer to Fastener Notice.
Install the stabilizer shaft link bolt and nut.
Tighten the stabilizer shaft link nut to 23 Nm (17 ft. lbs.).
3. Install the tire and wheel assembly.
4. Lower the vehicle.