Impala V6-3.8L SC VIN 1 (2005)
5. Remove the screws from the front fender liner.
6. Drill out the plastic rivet from the front rocker panel to front fender liner, if equipped.
7. Remove the front fender liner.
Installation Procedure
1. Position the fender liner to the fender, over the stud and behind the rocker molding.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the nut to the stud at the rear of the front fender liner.
Tighten the front fender liner stud nut to 4 N.m (35 lb in).
3. Install the screws to the front fender liner at the front bumper fascia.
Tighten the front fender liner to front bumper fascia screws to 2 N.m (18 lb in).
