Impala V6-3.8L SC VIN 1 (2005)
Notice: Refer to Fastener Notice in Service Precautions.
1. Install a new clip retainer to the upper side rail, if necessary.
Tighten the retainer screw to 2 N.m (18 lb in).
2. Align the garnish molding lower leg to the front door carpet retainer and to the front door weatherstrip.
3. Align the garnish molding to the trough on the upper instrument panel trim panel.
4. Align the garnish molding retainers to the windshield pillar.
5. Slide the roof leg under the center pillar trim panel.
6. Align the garnish molding to the clip retainers on the upper side rail.
7. Install the garnish molding, applying pressure at all the retainers until fully seated.
