Impala V6-3.8L SC VIN 1 (2005)
Power Mirror Motor: Procedures
MOTOR REPLACEMENT - POWER MIRROR
REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Disconnect the electrical connector to the mirror wire harness.
3. Remove the mirror face.
CAUTION: Refer to Eye Protection Caution in Service Precautions.
4. Remove the screws from the mirror motor.
5. Pull the motor electrical harness through the mirror housing.
6. Remove the motor from the mirror housing.
INSTALLATION PROCEDURE
1. Position the motor to the mirror housing.
2. Pull the motor electrical harness through to the inside door panel.
3. Install the screws to the mirror motor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the mirror motor screws to 10 N.m (89 lb in).
