Impala V6-3.8L SC VIN 1 (2005)
Power Mirror Switch: Procedures
POWER MIRROR SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the front door pull cup from the front door inner trim panel.
2. Disconnect the electrical connectors from the power mirror switch.
3. Remove the power mirror switch from the front door pull cup, using a small flat-bladed tool at the side of the mirror switch in order to release the
mirror control switch retainer.
4. Remove the power mirror switch from the front door pull cup.
INSTALLATION PROCEDURE
1. Install the power mirror switch to the front door pull cup pressing into place until fully seated.
2. Connect the electrical connectors to the power mirror switch.
3. Install the front door pull cup to the front door trim panel.
