Impala V6-3.8L SC VIN 1 (2005)
Power Seat Drive Cable: Service and Repair
Drive Cable Replacement - Vertical
Drive Cable Replacement - Vertical
Removal Procedure
1. If the seat is equipped with a driver side air bag, disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
2. Remove the front seat bolts.
3. Remove the head restraint.
4. Tip the seat forward and disconnect the electrical connector from the seat electrical harness.
5. Disengage the seat hook attachments from the floor pan.
6. Tip the seat forward to expose the vertical drive cables (3,4).
7. To remove either cable perform the following procedure:
1. Bend the flexible cable at the center.
2. Pull the cable out of the motor (1,2) and the drive screw.
Installation Procedure