Impala V6-3.8L SC VIN 1 (2005)
3. Install the engine cooling fan blade.
4. Install the engine cooling fan blade nut.
^
Tighten the nut to 6 Nm (53 inch lbs.).
5. Install the engine cooling fan heat shield.
6. Important: Ensure the lower edge of the fan shroud engages the clip at the bottom of the radiator.
Install the cooling fan shroud.
7. Install the cooling fan shroud bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
8. Install the cooling fans electrical harness to the fan shroud clips.
9. Connect the engine cooling fan motors electrical connector.