Impala V6-3.8L SC VIN 1 (2005)
Air Door Actuator / Motor: Service and Repair
Air Temperature Actuator - Right
AIR TEMPERATURE ACTUATOR REPLACEMENT - RIGHT
REMOVAL PROCEDURE
1. Remove the right side instrument panel (I/P) insulator.
2. Remove the I/P compartment.
3. Disconnect the electrical connector from the right air temperature actuator.
4. Remove the screws retaining the right air temperature actuator (2).
5. Remove the right air temperature actuator from the HVAC module assembly.
INSTALLATION PROCEDURE
1. Position the right air temperature actuator (2). Align the slots in the electric actuator driver to the flats on the shaft.
2. Align the locating hole to the alignment pin on the HVAC module case.
3. Slide the actuator on the shaft. The actuator driver should seat completely onto the shaft and the mounting holes should be flush with the mounting
screws on the HVAC module case.
4. Install the screws to the right air temperature actuator.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.5 N.m (13 lb in).
5. Connect the electrical connector to the right air temperature actuator.
6. Install the I/P compartment.
7. Install the right side I/P insulator.
