Impala V6-3.8L SC VIN 1 (2005)
2. Connect the side impact module - LF connector (1) located under the driver seat.
3. Install the CPA to the side impact module - LF connector (1).
4. Remove the SDM fuse.
5. Install the fuse block access cover.
6. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
7. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle in Vehicle DTC Information. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check -
Vehicle
SIR Disabling and Enabling Zone 9
SIR DISABLING AND ENABLING ZONE 9
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Service Precautions.
1. Turn the steering wheel so that the vehicle wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition switch.
4. Remove the instrument panel (I/P) fuse block cover.
IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation, and does not indicate
an SIR system malfunction.
5. Remove the SDM fuse.
6. Remove the RH I/P access hole cover.
7. Remove the connector position assurance (CPA) from the I/P module connector, located at the RH side of the I/P.
8. Disconnect the I/P module connector.
