Impala V6-3.8L SC VIN 1 (2005)
13. Remove the buss bar(s) from the fuse block(s) using a terminal releasing tool, and pulling down and out on the buss bar.
14. Remove the buss bar(s) from the fuse block(s).
15. Release the clip retainers from the underhood fuse block(s) battery cable and buss bar terminals using a small flat-bladed tool.
16. Remove the underhood fuse block(s) battery cable and buss bar terminals from the fuse block by pulling down.
17. Remove the fuse block and lamp wiring harness from the vehicle, if required.
INSTALLATION PROCEDURE
1. Install the underhood fuse block(s) battery cable and buss bar terminals to the fuse block(s) by sliding up into place until fully seated.
