Impala V6-3.8L SC VIN 1 (2005)
7. Install the bolts to the buss bar jumper bar.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the jumper bar bolts to 9 N.m (80 lb in).
8. Install the plastic shields to the battery cable and buss bar terminals pressing into place until fully seated.
9. Position the underhood fuse block(s) to the underhood fuse block base retaining locks.
10. Install the underhood fuse block(s) into the underhood fuse block base retaining locks pressing in until fully seated.
11. Install new tape to the wiring harness at the base of the underhood fuse block base.
12. Position the underhood fuse block base to the shock tower.
13. Install the nuts to the underhood fuse block base.
Tighten the fuse block base nuts to 9 N.m (80 lb in).
