Impala V6-3.8L SC VIN 1 (2005)
1. Position the CKP sensor to the block.
2. Install the CKP sensor bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 30 N.m (22 lb ft).
3. Install the CKP sensor shield (1).
4. Connect the CKP sensor electrical connector.
5. Install the crankshaft balancer.
6. Install the right splash shield cover.
7. Lower the vehicle.
8. Connect the negative battery cable.
9. Perform the Crankshaft Variation Learn Procedure. See: Testing and Inspection/Programming and Relearning
