Impala V6-3.8L SC VIN 1 (2005)
9. Install the fuel injector electrical harness clips holding harness to the front and the rear of fuel rail.
10. Connect the fuel injector electrical connectors.
11. Install the bypass valve actuator.
12. Install the rear generator mounting bracket and generator.
13. Install the ignition coil wires to the coil, and the retainer clips to the top of super charger.
14. Connect the vacuum line to the fuel pressure regulator.
15. Connect the fuel feed pipe (2) and the fuel return pipe (1) to the fuel rail.
16. Connect the negative battery cable.
17. Inspect for leaks.
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
18. Install the fuel injector sight shield.
