Impala V6-3.8L SC VIN 1 (2005)
Boost Solenoid: Service and Repair
BOOST CONTROL SOLENOID REPLACEMENT
REMOVAL PROCEDURE
1. Remove the fuel injector sight shield.
2. Disconnect the boost source and signal hoses from the boost control solenoid (2).
3. Disconnect the boost control solenoid electrical connector.
4. Remove the boost control solenoid nut.
5. Remove the boost control solenoid (2).
INSTALLATION PROCEDURE
1. Install the boost control solenoid (2).
2. Install the boost control solenoid nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 8 N.m (71 lb in).
3. Connect the boost control solenoid electrical connector.
4. Connect the boost source and signal hoses to the boost control solenoid (2).
5. Install the fuel injector sight shield.
