Impala V6-3.8L SC VIN 1 (2005)
Seat Heater Control Module: Procedures
HEATED SEAT CONTROL MODULE REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Position the seat to the full-up position.
2. Remove the bolts that secure the front seat frame to the floor.
3. Rotate the seat forward to access the heater module.
4. Disconnect the seat electrical harness connector.
5. Disconnect the heater control module from the seat frame by sliding the control module toward the front of the seat.
6. Disconnect the electrical harness connector (1) from the heater module (2).
7. Remove the heater module from the front seat.
INSTALLATION PROCEDURE
1. Position the heater module to the front seat.
2. Connect the electrical harness connector (1) to the heater module (2).
3. Position the module on the frame and slide the module rearward until the module locks into place.
4. Lower the seat.
5. Connect the seat electrical harness connector.
6. Install the bolts that secure the front bucket seat adjuster to the floor pan.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 42 N.m (31 lb ft).
7. Reposition the front seat to the original position.
