Impala V6-3.8L SC VIN 1 (2005)
9. When deploying an I/P module, refer to the following instructions:
1. Place the J 39401-B (2) in the center of the cleared area.
2. Fill the deployment fixture with water or sand.
3. Mount the I/P module (1) in the deployment fixture (2) with the vinyl/plastic trim facing up.
4. To mount, use 4 M 6 bolts (6), nuts (8), and washers (7) in order to properly secure the I/P module (1) to the deployment fixture.
5. Securely tighten all fasteners prior to deployment.
10. When deploying the side impact module - LF, refer to the following instructions:
0. Place the J 39401-B (3) in the center of the cleared area
1. Fill the deployment fixture with water or sand
2. Mount the side impact module - LF (1) in the deployment fixture (3) with the vinyl/plastic trim cover facing up.
3. Adjust and secure the J 39401-B arms (4) to the deployment fixture (3).
4. To mount, use 2 M 6 x 1.0 nuts (2) with washers in order to secure the side impact module - LF (1) to the deployment fixture arms (4).
5. Securely tighten all fasteners prior to deployment.
11. Inspect the J 38826 SIR deployment harness (1) and the appropriate pigtail adapter (2) for damage. Replace as needed.
12. Short the two SIR deployment harness (1) leads together using one banana plug seated into the other.
13. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
IMPORTANT: Refer to the Tools Required list for the correct adapter.
14. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
