Impala V6-3.8L SC VIN 1 (2005)
Connector End Views for determining the high and low circuits.
7. Strip 13 mm (0.5 in) of insulation from all 4 SIR wires connector leads.
8. Cut two 4.6 m (15 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used for the steering wheel
module deployment harness.
9. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
10. Twist together 1 end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.
11. Twist together 2 connector wire leads, the high circuits from both stages of the steering wheel module, to one of the deployment harness wires.
Refer to SIR Connector End Views in order to determine the correct circuits.
12. Inspect that the 3 wire connection is secure.
13. Bend flat the twisted connection.
14. Secure and insulate the 3 wire connection to the deployment harness using electrical tape.
