Impala V6-3.8L SC VIN 1 (2005)
15. Twist together 2 connector wire leads, the low circuits from both stages of the steering wheel module, to the deployment harness wire. Refer to
SIR Connector End Views in order to determine the correct circuits.
16. Inspect that the 3 wire connection is secure.
17. Bend flat the twisted connection.
18. Secure and insulate the 3 wire connection to the deployment harness using electrical tape.
19. Connect the deployment harness to the steering wheel module connector.
20. Route the deployment harness out of the driver side of the vehicle.
