chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Malfunction Lamp / Indicator, Air Bag > < Side Air Bag|Locations|Page 10524
Page 1
background image

Side Air Bag: Service and Repair

INFLATABLE RESTRAINT SIDE IMPACT MODULE REPLACEMENT - FRONT

REMOVAL PROCEDURE

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7.

CAUTION:
-

Refer to SIR Caution in Service Precautions.

-

Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.

2. If the air bag has been deployed, replace the seat back trim, the seat back pad, and the seat back frame Refer to Seat Back Frame Replacement -

Front in Seats.

CAUTION:
-

Following the deployment of a side impact air bag, replace the following parts:
-

The seat back trim

-

The seat back pad

-

The seat back frame

Failure to do so may cause future personal injury.

3. Remove the seat back cover, as needed. The head restraint does not need to be removed. Refer to Seat Back Cover Replacement - Front in Seats.

4. Remove the driver side air bag fasteners (2).
5. Note the routing of the air bag wiring harness (4) and the retaining clip attachments within the driver seat.
6. Remove the wiring harness (4) retaining clips from the driver seat frame.
7. Gently pull the pigtail harness up into the seat cushion and the seat back, while guiding the harness through the wire triangle of the seat frame.
8. Remove the module (1) from the driver seat back frame.
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required

retention period. Refer to Inflator Module Handling and Scrapping.

INSTALLATION PROCEDURE

1. Install the module (1) to the seat while guiding the pigtail harness through the trim cup.
2. Install the driver side air bag fasteners (2).

NOTE:  Refer to Fastener Notice in Service Precautions.

Tighten the fasteners to 10 N.m (89 lb in).

3. Gently pull the wiring harness (4) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
4. Install the harness retaining clips to the seat frame.
5. Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7.

Malfunction Lamp / Indicator, Air Bag > < Side Air Bag|Locations|Page 10524