Impala V6-3.8L SC VIN 1 (2005)
9. Remove the LH insulator panel.
10. Remove the CPA from the steering wheel module coil connector located at the base of the steering column.
11. Disconnect the steering wheel module coil connector.
12. Remove the CPA from the side impact module - LF connector (1), located under the driver seat.
13. Disconnect the side impact module - LF connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the side impact module - LF connector (1), located under the driver seat.
3. Install the CPA to the side impact module - LF connector.
4. Connect the steering wheel module coil connector.
5. Install the CPA to the steering wheel module coil connector located at the base of the steering column.
6. Install the LH insulator panel.
