Impala V6-3.8L SC VIN 1 (2005)
Seat Belt Retractor: Service and Repair
Seat Belt Retractor Replacement - Center Rear
REMOVAL PROCEDURE
1. Remove the rear shelf trim panel.
2. Remove the rear seat retractor seat belt bolt.
3. Remove the rear seat belt retractor from the vehicle.
INSTALLATION PROCEDURE
1. Position the center, rear seat belt retractor on the rear shelf.
IMPORTANT: The anti-rotation tab must be in the proper hole in the rear shelf.
2. Install the rear seat belt retractor bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolt to 68 N.m (50 lb ft).
3. Install the rear shelf trim panel.