Impala V6-3.8L SC VIN 1 (2005)
Control Arm Bushing: Service and Repair
Lower Control Arm Bushings Replacement (Horizontal)
Lower Control Arm Bushings Replacement (Horizontal)
^
Tools Required
-
J 21474-01 Control Arm Bushing Service Set
-
J 21474-5 Control Arm Bushing Receiver
Removal Procedure
1. Remove the lower control arm.
2. Secure the lower control arm in a vise.
Important: Use a 1/2 x 20 in standard thread nut with the puller bolt.
3. Assemble the bushing removal tools as indicated:
a. The nut (1)
b. The J 21474-01 washer (2)
c. The J 21474-01 bearing (3)
d. The J 21474-5 (4)
e. The J 21474-01 puller bolt (5)
4. Tighten the puller bolt (5) until the bushing is removed.
5. Disassemble the J 21474-01 and J 21474-5.
Installation Procedure
1. Lubricate the bushing with liquid hand soap or equivalent.
Important: Use a 1/2 x 20 in standard thread nut with the puller bolt.