Impala V6-3.8L SC VIN 1 (2005)
2. Assemble these bushing installation tools as indicated :
a. The nut (1)
b. The J 21474-01 washer (2)
c. The J 21474-01 bearing (3)
d. The J 21474-5 (4)
e. The J 21474-01 puller bolt (5)
3. Tighten the puller bolt (5) until the bushing is installed into the control arm.
4. Disassemble the J 21474-01 and J 21474-5.
5. Remove the control arm from the vice.
6. Install the lower control arm.
