Impala V6-3.8L VIN K (2004)
1. Install the antenna cable to the vehicle. Use electrical tape in order to secure the antenna extension cable to the top of the wiring harness. Secure
the cable to the harness at least every 150 mm (6 in).
IMPORTANT: The antenna cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.
2. Connect the antenna extension cable from the radio to the antenna cable near the kick panel:
2.1.
Position the antenna extension cable behind the sliding lock feature.
2.2.
Install the antenna extension cable to the sliding lock feature.
3. Install the carpet.
4. Install the lower center pillar trim panel.
5. Install the left carpet retainers.
6. Install the rear seat back.
7. Install the rear seat cushion.
IMPORTANT: The antenna cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.
8. Connect the antenna cable to the radio antenna module:
8.1.
Position the antenna cable behind the sliding lock feature.
8.2.
Install the antenna cable to the sliding lock feature.
9. Install the rear upper quarter trim panel.
