Impala V6-3.8L VIN K (2004)
3. Apply tape and mark the location as shown.
4. Heat the mounting surface to approximately 27-41°C (80-105°F).
5. Ensure that the temperature of the body side molding is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing of the body side molding.
6. Remove the protective liner from the back of the body side molding.
7. Position the body side molding to the location marks and press the molding to the mounting surface.
8. Apply equal pressure along the body side molding to uniformly bond the item to the mounting surface.
9. Remove the protective tape from the mounting surface.
