Impala V6-3.8L VIN K (2004)
Ash Tray: Procedures
Ashtray Replacement
ASHTRAY REPLACEMENT
REPLACEMENT PROCEDURE
1. Remove the instrument panel (IP) cluster trim plate.
2. Remove the IP ashtray.
3. Remove the IP ashtray bracket screws (1).
4. Remove the IP ashtray bracket.
5. Disconnect the electrical connector from the ashtray.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the ashtray.
2. Install the IP ashtray bracket to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the IP ashtray bracket screws (1).
Tighten
Tighten the screws to 2 N.m (18 lb in).
4. Install the IP ashtray.
5. Install the IP cluster trim plate.
