Impala V6-3.8L VIN K (2004)
Sun Visor: Removal and Replacement
Sunshade Replacement
Sunshade Replacement
Removal Procedure
The sunshades can be equipped with an illuminated vanity mirror. The illuminated vanity mirror is not serviced as a separate unit.
1. Position the sunshade so the bottom edge is pointing straight down.
2. Remove the sunshade from the sunshade anchor and position the sunshade between the sunshade anchor and the windshield.
3. Remove the screws from the sunshade.
4. Once the retainer shaft releases the sunshade will begin to separate from the bezel. Some back-and-forth movement may be necessary to release
sunshade from the retainer.
5. Disconnect the electrical connector from the sunshade if equipped.
6. Remove the sunshade from the vehicle.
Installation Procedure
1. Connect the electrical to the sunshade connector if equipped.
2. Position the sunshade to the mounting point at the roof.
3. Position the sunshade just behind the sunshade anchor.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the sunshade screws.
Tighten the sunshade screws to 2 N.m (18 lb in).
5. Position the sunshade into the sunshade anchor.
Sunshade Anchor Replacement
Sunshade Anchor Replacement
Removal Procedure
