Impala V6-3.8L VIN K (2004)
Notice: Refer to Fastener Notice in Service Precautions.
11. Install the nuts to the interface module bracket.
Tighten the nuts to 4 N.m (35 lb in).
12. Install the plastic cover on the On-Star module.
13. Install the convenience net and retainers, if equipped.
14. Install the tail lamp retainers.
15. If equipped, install the sill plate. Refer to Compartment Sill Plate Replacement - Rear.
16. If the vehicle is not equipped with a sill plate, install the push-in retainers beside the lock striker.
17. Close the rear compartment.
Garnish Molding Replacement
GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR (IMPALA)
REMOVAL PROCEDURE
1. Remove the windshield garnish molding from the clip retainers on the upper side rail.
2. Slide the roof leg of the garnish molding out from under the center pillar trim panel.
