Impala V6-3.8L VIN K (2004)
1. Install EBCM onto the BPMV(1) if replacing the BPMV only.
2. Install BPMV and EBCM as an assembly (1) to the mounting bracket (2).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the 4 bolts (3) that connects the BPMV assembly (1) to the mounting bracket (2).
^
Tighten the 4 bolts (3) that connect the BPMV (1) to the mounting bracket (2) to 10 Nm (89 inch lbs.).
4. Install the BPMV bracket (4) to the strut tower.
5. Install the 1 bolt and 3 nuts that attach the BPMV, mounting bracket (4) to the strut tower.
^
Tighten the lower 2 BPMV mounting bracket nuts (3) and bolt to 10 Nm (84 inch lbs.).
^
Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 Nm (27 inch lbs.).
Caution: Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake wheel
lockup will occur and personal injury may result The only two ways this condition can be detected are by using a Scan Tool or by doing an
Antilock stop.
Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings during the next few steps when ready.
