Impala V6-3.8L VIN K (2004)
6. Install the master cylinder brake pipes (2) into the BPMV (4).
^
Tighten the master cylinder brake pipe fittings to 24 Nm (18 ft. lbs.).
7. Install the brake pipes (1) on the BPMV (2).
^
Tighten all 4 brake pipe fittings to 24 Nm (18 ft. lbs.).
8. Reconnect the ground strap between the EBCM assembly and the chassis.
9. Connect the EBCM harness connector.
10. Push down lock tab (1) and then move sliding connector cover (2) back in home position to lock.
11. Insert red locking tab back in place.
12. Reinstall the cruise control module.
13. When all procedures have been completed, the automated ABS bleed procedure is required.
