Impala V6-3.8L VIN K (2004)
1. Install the traction control switch (1) to the IP cluster trim plate (2).
2. Connect the electrical connector (1) to the traction control switch (2).
3. Align and carefully press the IP cluster trim plate into the IP trim pad. Make sure all of the retainers are fully engaged.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the LH IP cluster trim plate screws.
^
Tighten the IP cluster trim plate screws to 2 Nm (18 inch lbs.).
5. Install the LH instrument panel (IP) fuse block access opening covers.
6. Install the ignition switch cylinder bezel.
7. Return the steering wheel to the original position.
8. If equipped with a column shift, position the transaxle shift control indicator to Park.
9. If equipped with column shift, release the parking brake.
