Impala V6-3.8L VIN K (2004)
11. Remove the caliper bolts (1 and 3).
12. Remove the caliper (3) from the rotor (4) and the caliper bracket (1).
13. Inspect the caliper bracket bolt boots on the caliper bracket for the following conditions:
^
Cuts
^
Tears
^
Deterioration Replace any damaged caliper bracket bolt boots.
14. Inspect the caliper bolts (2) for corrosion or damage. If corrosion is found, use new caliper bolts, including bushings, when installing caliper.
Installation Procedure
1. Install the caliper (3) over the rotor (4) and the caliper bracket (1). Ensure that the bushings are in place.
2. Lubricate the caliper bolts (1 and 3). Use silicone grease. Do not lubricate the threads.
3. Lubricate the 2 bolt boots (13 and 4) in the caliper bracket (12). Use silicone grease.