Impala V6-3.8L VIN K (2004)
There should not be any kinks in the hose.
Align the hose fitting with the notch in the bracket. Use the hose paint stripe as a visual aid.
4. Install the retainer onto the hose fitting at the bracket.
5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
6. Connect the brake pipe fitting to the brake hose:
^
Use a backup wrench on the hose fitting.
^
Do not bend the bracket or pipe.
^
Tighten the brake pipe fitting to 15 Nm (11 ft. lbs.).
7. Install the rear tire and wheel assembly.
8. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
9. Bleed the hydraulic brake system.
10. Lower the vehicle.
