Impala V6-3.8L VIN K (2004)
9. Disconnect the master cylinder brake pipes (2) from the BPMV (4).
10. It is not necessary to remove the brake pipes (2) from the master cylinder (1).
11. Swing the 2 master cylinder brake pipes out of the way only after covering the open pipes to avoid dripping or being contaminated.
12. Remove the 2 BPMV mounting bracket nuts (3) and 1 bolt located near the bottom and one nut (1) located at the top of the BPMV mounting
bracket (4) to the strut tower.
13. Disconnect the ground strap between the EBCM assembly and the chassis.
14. Remove the BPMV mounting bracket (4) and EBCM assembly (2) from the vehicle.
15. Remove the 4 bolts (3) that connect the BPMV (1) to the mounting bracket (2).
16. Remove EBCM if replacing the BPMV only.
Installation Procedure
