Impala V6-3.8L VIN K (2004)
14. Install the A/C compressor bracket and the A/C compressor bracket bolts.
-
Tighten the A/C compressor bracket bolts to 50 Nm (37 ft. lbs.).
15. Install the A/C compressor and the A/C compressor nuts.
-
Tighten the A/C compressor nuts to 30 Nm (22 ft. lbs.).
16. Install the power steering oil cooler pipe brackets to the frame.
17. Install the right engine splash shield.
18. Install the right front tire and wheel.
19. Lower the vehicle.
20. Remove the engine support fixture.
21. Install the right and left engine mount struts.
22. Install the air inlet duct to the throttle body.
23. Connect the intake air temperature (IAT) sensor electrical connector.
24. Install the drive belt.
25. Install the fuel injector sight shield.
26. Connect the negative battery cable.
