Impala V6-3.8L VIN K (2004)
1. Install the engine oil cooler/power steering cooler to the vehicle.
Notice: Refer to fastener Notice in Service Precautions.
2. Install the upper bolt (1) to the engine oil cooler/power steering cooler bracket.
-
Tighten the bolt to 2 Nm (18 inch lbs.).
3. Install the lower bolts (2) to the engine oil cooler/power steering cooler bracket.
-
Tighten the bolts to 2 Nm (18 inch lbs.).
4. Install the engine oil cooler lines to the engine oil cooler.
5. Install the power steering oil cooler lines to the power steering cooler.
6. Reposition the hose clamps on the power steering cooler lines.
7. Install the support clip to the engine oil cooler lines.
8. Install the right engine splash shield.
9. Position the radiator air baffle to the vehicle. Tilt the rear of the air baffle upward slightly. Position the upper clip of the air baffle to the lower
edge of the front fascia support C-channel.
10. Slide the baffle towards the front of the vehicle in order to completely engage the upper and lower clips of the baffle onto the fascia support.
11. Align the tabs at the rear of the air baffle to the openings in the upper radiator support.
12. Install the radiator air baffle retainers.
13. Add the proper amount of engine oil and power steering fluid.
