Impala V6-3.8L VIN K (2004)
9. Connect the electrical connectors to the following:
^
Mass air flow (MAP) sensor
^
Manifold absolute pressure (MAP) sensor
^
Idle air control (IAC) valve
^
Throttle position (T/P) sensor
^
EVAP purge solenoid
10. Install the throttle body upper support bracket bolt.
Tighten
Tighten the bolt to 10 Nm (89 lb in).
11. Install the EGR valve wiring harness heat shield nut and the bolt.
Tighten
Tighten the nut and the bolt to 10 Nm (89 lb in).
12. Install the brake booster hose to the vacuum source manifold.
13. Install the fuel rail assembly.
14. Install the right spark plug wires.
15. Install the air cleaner intake duct.
16. Install the fuel injector sight shield.
17. Connect the negative battery cable.
18. Fill the cooling system.
19. Inspect for fluid or vacuum leaks.
