Impala V6-3.8L VIN K (2004)
1. Connect the electrical connectors to the HVAC control module.
2. Install the HVAC control module into the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the retaining screws to secure the HVAC control module.
Tighten
Tighten the screws to 1.8 N.m (16 lb in).
4. Install the instrument panel trim plate bezel.
IMPORTANT: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper
HVAC performance will result.
5. Start the engine and run for one minute.
