Impala V6-3.8L VIN K (2004)
Headlamp Switch: Service and Repair
HEADLAMP SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel cluster trim plate bezel.
2. Remove the screws from the headlamp switch housing.
3. Remove the headlamp switch housing from the instrument panel.
4. Disconnect the electrical connector from the headlamp switch.
5. Disconnect the electrical connector from the foglamp switch.
6. Remove the foglamp switch from the headlamp switch housing, using a small flat bladed tool.
INSTALLATION PROCEDURE
1. Install the foglamp switch to the headlamp switch housing, pressing into place until fully seated.
2. Connect the electrical connector to the headlamp switch.
3. Connect the electrical connector to the foglamp switch.
4. Install the headlamp housing switch to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the screws to the headlamp housing switch.
Tighten
Tighten the headlamp housing switch screws to 2 N.m (18 lb in).
6. Install the instrument panel cluster trim plate bezel.