Impala V6-3.8L VIN K (2004)
7. Pull the spot lamp with the outer tube shaft out of the spot lamp mounting bracket and set aside.
8. Remove the spot lamp mounting bracket screws.
9. Remove the mounting bracket and the gasket from the windshield pillar.
10. Clean the mounting surface of the windshield pillar.
INSTALLATION PROCEDURE
IMPORTANT: This method of installation will stop the chance of any alignment and binding problems.
1. Install the mounting bracket and the gasket on to the spotlamp outer tube shaft.
2. Apply a small amount of RTV sealer GM P/N 12345336 or Canadian P/N 12346286 or equivalent to the screw holes on the windshield pillar.
3. Install the mounting bracket , the gasket and the spotlamp outer tube shaft through the windshield pillar.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the spot lamp mounting bracket screws.
Tighten
Tighten the spot lamp mounting bracket screws to 3.5 N.m (31 lb in).
5. Rotate the spot lamp to the upright position.
Point the spot lamp forward.
6. Tighten the spot lamp mounting bracket set screw just enough in order to firmly hold the spot lamp in the upright position.
