Impala V6-3.8L VIN K (2004)
1. Install the wheel bearing/hub with the splash shield as noted during removal.
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install NEW wheel bearing/hub bolts.
^
Tighten the NEW wheel bearing/hub bolts to 130 Nm (96 ft. lbs.).
3. Install the brake rotor and caliper.
4. Install the front wheel drive shaft nut. Insert a drift on a flat bladed tool into caliper and rotor to prevent the rotor from turning.
^
Tighten the front wheel drive shaft nut to 160 Nm (118 ft. lbs.).
Important: Ensure that the connector clip engages the bracket properly.
5. Install the wheel speed sensor electrical connector to the bracket, if equipped.
