Impala V6-3.8L VIN K (2004)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the engine oil pressure switch electrical connector.
3. Remove the oil pressure switch.
Installation Procedure
Notice; Refer to Fastener Notice in Service Precautions.
1. Install the engine oil pressure switch.
-
Tighten the switch to 16 Nm (12 ft. lbs.).
2. Connect the engine oil pressure switch electrical connector.
3. Lower the vehicle.