Impala V6-3.8L VIN K (2004)
6. Pull the connection apart.Repeat the step for the other fitting.
7. Wipe off the male pipe end using a clean shop towel.
8. Clean or replace the components/assemblies, as required.
INSTALLATION PROCEDURE
CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean
engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
1. Apply a few drops of clean oil to the male pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.
3. Pull on both sides of the quick connect fitting in order to ensure that the connection is secure.
4. Tighten the fuel filler cap.
5. Connect negative battery cable.
6. Inspect for fuel leaks.
6.1.
Turn ON the ignition for 2 seconds.
6.2.
Turn OFF the ignition for 10 seconds.
6.3.
Turn ON the ignition.
6.4.
Inspect for fuel leaks.
