Impala V6-3.8L VIN K (2004)
3. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
4. Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
5. Command the fuel pump ON with a scan tool.
6. Close the bleed valve on the fuel pressure gage.
7. Inspect for fuel leaks.
REMOVAL PROCEDURE
1. Place the fuel pressure gage bleed hose into an approved container. Open the bleed valve in order to bleed the fuel system pressure.
2. Place a shop towel under the fuel pressure gage in order to catch any remaining fuel spillage.
3. Remove the fuel pressure gage from the fuel pressure connection.
4. Drain any fuel remaining in the fuel pressure gage into an approved container.
5. Inspect for leaks using the following procedure:
5.1.
Turn ON the ignition, with the engine OFF for 2 seconds.
5.2.
Turn OFF the ignition for 10 seconds.
5.3.
Turn ON the ignition, with the engine OFF.
5.4.
Inspect for fuel leaks.
6. Install the cap on the fuel pressure connection.
7. Install the fuel injector sight shield.
